![]() If the problem is not the spring, it will be hard for any user to find the faulty part. Possible ReasonsĪ weak or faulty return spring is the primary reason for the trigger reset problem.Īlso, one or two components in the trigger mechanism can become faulty causing the trigger to stick in one place. It can be very dangerous in emergency situations. In some cases, the PC Carbine’s trigger gets stuck and doesn’t reset. Lastly, clean the gun on a regular basis. Maintaining proper grip and avoiding limp wristing are two possible solutions to the problem. Hence, it may not cause any problems during the extraction. Then, rack the slide, and assess downrange which will ensure proper ammo loading. The Fixįor a simple and quicker solution, you can try tapping the bottom of the magazine so that it sits properly. When the magazine doesn’t sit properly, it can cause stovepiping. It is very common among semi-automatic firearms. Some may indicate the problem as the result of using a Glock magazine.īut it is not true because I have seen some users facing similar issues with Ruger magazines.Īs stove pipe issue means fired shell not extracting, you can call it an extraction failure too. This problem looks somewhat like the picture below. Those who can’t pinpoint the reason should take the gun to a gunsmith or send it to Ruger for the right solution. You can understand that jamming occurs for various reasons. It can be the ammo, sights, rough feed ramp, weak spring, and many more. There are other possibilities for potential feeding and accuracy problems. Tighten the tension ring, and the gun is ready to operate smoothly. You can understand that the reason for these problems is unique. If the tension ring on the barrel is not tight enough, you will face these issues. I am calling it a Ruger PC Carbine jamming problem as it covers the whole range of problems due to jamming.įor both ammo feeding issues and accuracy problems, there can be one single reason. Additionally, it can introduce an accuracy problem too. Your PC Carbine may get jammed resulting in a feeding problem. Also, it will allow you to shoot different ammo without any issues. ![]() It should do the trick as many users got benefit from the trick. ![]() Use a 4” vise grip to hold the ejector and bend it very little so that it can touch the channel in the bottom of the bolt. Lastly, I want to mention a risky DIY fix that requires some alteration of the ejector. If it fails to solve the issue, try replacing the recoil spring and retainer. Or, you can buy these components by yourself. You may urge to modify certain parts of the gun to solve this issue but I don’t recommend it for those who are relying on the Ruger warranty.Ĭontacting Ruger, you may get a new extractor, pin, and spring as a replacement. The obvious first step of this trial and error method is to change the ammo brand. Then, you should inspect all components related to the extraction mechanism.Īlso, don’t forget to check the recoil spring and retainer as they can cause a similar problem too. Possible Reasonsįor the Ruger PC Carbine extractor issue, the first thing to suspect is the type of ammunition you are using. Lots of complaints indicate that Ruger PC Carbine has a problem with ejecting fired shells. Trigger Stuck Replace the weak return spring or the whole trigger kit. Stovepiping Sit the magazine properly, change the ammo brand, and avoid limp wristing. Feeding Failure Tighten the tension ring on the barrel, change ammo, correct the sights, polish the feed ramp, or replace weak springs. Problems Solutions Failure to Eject Change the ammo brand, bend the ejector slightly, or send the gun to Ruger.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |